VWD is the most common type of bleeding disorder, affecting an estimated one percent of the world’s population. It affects females and males equally. However, because symptoms can be mild, many affected people have not been diagnosed or do not get diagnosed until later in life. If you have VWD, you might be missing or have a deficiency of VWD factor (VWF). You might also have plenty of VWD factor, but it doesn’t function properly. This means that your blood cannot successfully form a clot or a platelet plug or because the site of the bleed cannot receive enough FVIII because the VWF doesn’t transport it properly. VWD is usually hereditary, but it can also be acquired. VWD heredity is very complicated. Acquired VWD is referred to as acquired von Willebrand Syndrome (aVWS). People with VWD who have access to factor replacement therapy and other bleeding management medications have a normal life expectancy and are able to lead a fairly normal life. VWD is more frequently diagnosed in females because it causes menorrhagia in about 70% of cases; however, bleeding may decrease during pregnancy and childbirth due to hormonal changes raising levels of VWF and FVIII. In addition, it may be more severe in people with an ‘O’ blood type.

VWF has two roles in clotting:

  • It makes platelets stick together to form a platelet plug.
  • It ensures that there is enough FVIII in the bloodstream, binds to FVIII and carries it to the site of injury, and protects it from being broken down in the bloodstream.

Types of VWD:

There are five types of VWD: VWD type 1, VWD type 2, VWD type 3, pseudo-VWD, and acquired. VWD types 1 and 3 are quantitative, which means that if you have either of these types, you have a VWF deficiency. VWD type 2 is qualitative, which means that you might have enough VWF, but it doesn’t function properly, and it has several subtypes (in order of commonality: 2a, 2b, 2n, and 2m). Because each type and subtype of VWD has different treatments and therapies, it is important for you to know which type you have.

VWD Type 1

VWD Type 1 is the most common (70% to 80% of those with VWD have this). If you have Type 1 VWD, your VWF works properly, but you do not have enough VWF in your bloodstream, which may challenge clotting ability and cause bleeding. Because VWF carries FVIII to the site of an injury, you may also have a low level of FVIII in your bloodstream. Many individuals with VWD type 1 are diagnosed late in life after a serious injury or a surgery.

VWD Type 2

VWD type 2 is the next most common (15% to 30% of those with VWD have one of the VWD type 2 subtypes). If you have VWD type 2, your VWF does not function properly, so even if you have plenty of it, you can still have bleeds. In order to understand VWD type 2, you need to know that the VWF protein has something called “multimers,” which bind it to platelets and FVIII. If the multimers are the wrong size or shape (or there aren’t enough of them), your VWF will not bind to platelets or FVIII, or it will bind at the wrong time. Since VWF is what stabilizes FVIII and carries it to the site of an injury, if this binding does not occur, either platelets do not get carried to the injury site to form a platelet plug, or FVIII does not get carried to the injury site to form a successful (fibrin) clot. (This can also cause circulating FVIII to be low, leading to a temporary misdiagnosis of hemophilia A.) The way each subtype of VWD type 2 malfunctions is a little different and may have different treatments and therapies that will work, so you need to know which subtype (2a, 2b, 2n, or 2m) you have:

Type 2a: If you have VWD type 2a, your VWF level is likely low, but the real problem is that you do not have enough large VWF multimers (cleaved multimers are too small and can’t cause adhesion) because they aren’t formed, which prevents your platelets from sticking together to make a good platelet plug.

Type 2b: If you have VWD type 2b, your VWF factor is likely low, but the real problem is that you do not have enough large VWF multimers because, after their secretion, they get bound to the platelets too soon (before an injury even happens). They then become cleaved, and the remaining cleaved multimers can’t bind to platelets. The body gets rid of the multimers that were bound to platelets too early, causing a shortage of both platelets and VWF in the blood, so you cannot form a platelet plug.

Type 2n: If you have VWD type 2n, your VWF works normally with platelets (so you will form the platelet plug), but it is not able to bind to FVIII and carry it to the site of an injury. Since VWF binding to FVIII is what stabilizes FVIII, you will also have low FVIII levels, challenging your ability to make a fibrin clot. (Due to the low FVIII caused by this, some individuals are temporarily misdiagnosed with mild hemophilia A.)

Type 2m: If you have VWD type 2m, you have approximately the right number of multimers, but your VWF is not able to bind to the platelets, so you cannot form a platelet plug.

VWD Type 3

If you have VWD type 3, you have the rarest type of VWD (about one person in a million) and usually the most severe symptoms. If you have VWD type 3, you have nearly undetectable or no VWF. Since VWF stabilizes and carries FVIII, you will also have low levels of FVIII. With low levels of both, you will not be able to form a platelet plug or a fibrin clot. This means that you can have spontaneous bleeding into your joints and muscles. In addition, you might have mucosal bleeds, such as nosebleeds, mouth bleeds, or menorrhagia. Due to the severity of symptoms, many are diagnosed with VWD type 3 at an early age.

Acquired VWD (aVWS)

If you have aVWS, you were not born with it. In fact, it occurs most often in individuals over 40 years of age with no prior bleeding history. aVWS usually occurs due to an additional disease state (e.g., tumor cell adhesion, and autoimmune response, or aortic stenosis).

Pseudo-VWD

If you have pseudo-VWD, also known as platelet-type VWD, your VWF levels are normal, your VWF is not defective, and your von Willebrand gene is not necessarily mutated. The real problem is actually with the platelet receptor, glycoprotein Ib (GPIb), in your blood that sometimes binds inactive platelets with VWF. These receptors are “over-active” and bind to the VWF too aggressively and too soon, so the body removes the bound platelet/VWF molecules, leaving you with potentially low platelet and VWF multimer levels.

Fun Facts About VWD

VWD is named after the Finnish doctor, Erik von Willebrand, who lived from 1870 to 1949. He was the first to describe VWD that he found in families in the Aland Islands. Although he could not identify the actual cause for the disorder, he was able to distinguish it from other bleeding disorders.

VWD type 2A used to be subclassified into types IIA, IIC, IID, and IIE, but discriminating between these subclassifications of type 2A did not show clinical utility, so they are all now referred to as type 2A.


Sign up for E-mails, Dateline Magazine, and other ways to stay connected.